configuring SNMP on Brocade fibre switches? They have made it so different than what I'm used to which is....just put in your community string, trap manager IP and port. So I'm trying to figure out how in the heck to do this :(

Attached is a pic of the config. As you can see it supports both v3 and v1. We have one trap manager and one community. I'd like to send 3 different trap levels to the same manager but see no way to do this from this screen. Their documentation is the suck too :(

HELP!!!!

Meh finally got the answer... IBM support had to call Brocade (whose documentation sucks much butt IMO). When I initially called IBM they told me and I quote:

"Oh, hrmm well we just read through our docs and we don't see anything about this. So we downloaded Brocades docs and well if you've read through it all you probably know more about it than us right now so we'll have to call Brocade for the answer. So sorry for tne inconvience we're really behind the curve on this, we dropped the ball."

*picks up jaw from desk* ummm ok.

Two hours later call back from Raliegh Network Support IBM.... sure change it however you want it will be documented in the future.

GUH.

sure change it however you want it will be documented in the future. This open-sourced? Sounds more like a response to a developer than to an end-user's request for help.

Nope it's not open source.

They were basically saying yes you can change the pre-definied fields we'll add this to the documentation later.

Do you get paid for Beta testing the software now? You should submit a bill....